50tech.com

I have a Ford Racing Cobra intake that I am planning on putting on my 86 GT. The car is still speed density and has the stock injectors; I was wondering what throttle body would the best to go with a 65mm or 70mm? Will my stock air idle and throttle body sensor still work ...

... got rid of my 90 hatch but missed it so much i traded for a 91 ssp fhp coupe it has gt40p heads ,cobra upper and lower, x 303 cam , tremec 5 speed tranny , king cobra clutch, 24 lb injectors ,tri ax shifter, ta performance rear end girdle, 355 gear ( ill probably change to a 373 ) and a lot ...

... Meter Pro Shift Light * Saleen A-Pillar Dual Gauge Pod * Auto Meter Ultra Lite Series Gauges * CGC Cowl Vent Panel * Gauge Cage * FMS 140 Speedometer * AFM Ashtray Panel * Pro3 Billet Shift Cover Plate * K&N Dual Bank A/F Ratio Meter * DC Control Fan Speed LED's Performance: ...

... went 12.40@110 mph on the motor N/A with this setup, on drag radials/skinnies with stock springs and removed sway bars. I have a NEW 88GT speed density 4.10 auto car that I'm starting a whole new build on. Plan on doing a similar build and using the same cam since I had so much success ...

can you provide more details on the suspension please... My goal is similar to yours.. I want my bolt-on 88 Coupe to run low 13's with suspension set-up. Here is what I have: HP Performance adjustable upper control arms Megabit Jr's lower control arms which relocate the lower control arm Strange ...

A few months ago I developed a problem with my 1993 Mustang 5.0 LX, 5 speed, with 160,000 miles, I have driven it for a year with no problems. The engine is stock except for a after market cold air filter. The problem is I was driving along at 60mph when, without ...

Nobody makes one off the shelf any more that I know of, but you can have one custom burned....

http://www.speedydyno.com

aleborjas wrote:who makes chip for SD cars?

I don't think anyone does these days, unless of course you have a DFI system which is SD. other than that, your best bet is to switch to MAF or live within the abilities of SD and match your parts as closely as possible staying on the safe side

who makes chip for SD cars?

87 mustang gt Speed Density 5spd rebuilt 302 500 or less miles on engine, w/ comp cam XE258HR-14 I'm guessing i'm getting gas in my oil pan. Front pan plug leaks a tad bit and had a clear liquid on it which smells like gas leaking ...

5 speed. 3" at idle 15" at 1500rpm

You could always go with a custom cam if you are dead set on the SD.

5 speed or auto?
Take any vacuum readings?

... the crower 15511 but i am in the process of building a 347 with Eagle h-beam rods and some flat top Probe pistons. i am looking to stay with my Speed Density setup as long as i can so what do you guys think about my cam? Stick with it or is there another cam anybody recomends that is 347 and ...

convert to m/a then there wont be an issue. its very easy to do