50tech.com

The pickup you changed, is that the piece inside the distributor? It's boring, but check for vacuum leaks. I don't think the idle bypass would cause this, but I'd clean it out. If I think of something else I'll pop in. Let me know how you make out.

... to look at? Not able to spend a lot of money right now (broke college kid spending too much on beer) so I'm trying to keep cost down for now. Let me know what you think

... again and it ran like a top . Every thing works except the horns. I called my alarm person and we agreed that the alarm must of stuck in Val let mode that caused the hornes to go off . I think that [color=#0000FF]is the first place I am going to have checked out. Prehaps a fuse for the horns ...

... 270 cam, says its good with SD, also about the 24# injectors I can just plug them in and they will be fine on the SD setup, SO if anyone wants to let me know what you think I plan on current mods in sig plus the trick flow top end kit, besides the cam going with the 270 and the intake already ...

Been looking on ebay...think I'll go with a 76mm MAF, probably C&L, may need to up the fuel pressure, I'll let you know, thanks

... THe one in the picture I attached is in fact a 73mm C&L with the stock electronics and a sample tube to use it with 24 pound injectors. Let us know. :D

... he couldn't tell me what it was doing either. go figure? So if anyone else has experienced this problem and knows how to fix it please, PLEASE let me know.

I just put in Bosch Platinum +2 spark plugs. They are not supposed to be gapped. I don't think the cable is binding. It you throttle it and then let go, the cable will go back to the idle position immediately but the engine doesn't.

... BTDC. It seems to idle fine at about 1300 RPM but if i lower it any more than it gets rough. The throttle is alittle sticky when WOT, but when you let off it comes down really slow. Kind of comes down, stops, comes down some more, stops, etc. I also have a granatelli 90mm mass air sensor, but i ...

Damn brother! So sorry to hear about that. I hope your doing ok still.. I know this post is a little old but just want to let you know how sorry Iam for your loss! :( Thank You, Don't worry about the late reply. Ya it sucks. now I'm the only 1 left, just hope my luck doesn't run ...

Damn brother! So sorry to hear about that. I hope your doing ok still.. I know this post is a little old but just want to let you know how sorry Iam for your loss!

... a spacer for your IAB which will allow you to adjust your idle with greater resolution. So this was the long of it, obviously, my appologies. Let us know what you find.

thought i'd drop a line & let ya'll know i'm still around & kicking :) it's been 1 heck of a new year already and only 2 months have gone by. sheesh. Lost my brother in Jan (still waiting for autopsy results) :( Been loading ...

... we're really looking forward to getting to know everyone on the site. Please check out our FAQ if you have any questions about us and definitely let us know what you think of our videos. Don't forget you can upload your own and the embed them here in the forum for everyone to see! http://www.nmratv.com

... it. There’s a lot of variety this year and pretty much something for everyone. You can even trick yourself out in some of the latest Mustang gear. Let’s take a look at what’s on tap. Read more...